網絡釋義

用法例句

When shearing force or axis force is relatively great, great errors of moment arise when the method of pure bending is employed.

當剪力或軸力較大時,用純彎曲方法計算彎矩誤差很大。

At present in most teaching material about mechanics of material published in China, the influence of interior shearing force on deformation are not considered when solving the deformation of beam.

目前大多國內出版的材料力學(工程力學)教材中,在求解梁的變形時均不考慮內力剪力對變形的影響,對此問題更不做詳細的定量描述。

Based on a comprehensive analysis of the two methods of calculating the internal force(shearing force and bending moment)——cross-section method and the law of internal force calculation,the paper evolves a short-cut method of calculation,namely,comparison method.

對彎曲變形梁內力(剪力和彎矩)的兩種計算方法,截面法和內力計算規則進行了綜合分析,總結出了一種更簡捷的計算方法:"比較法"。

The shear and bending moment of beam cross-section were calculated by the internal function of Excel.

根據Excel的內置函數求梁在橫截面上的剪力和彎矩。

The methods for calculating moments and shear force, then, be derived.

本文根據材料力學理論,對多支座臥式容器進行受力分析,給出了剪力和彎矩的計算方法,并對容器的應力計算進行分析,可作為工程設計參考。

This article explicates the mathematical model on shear forces as well as bending moments of bending beams,which serves as the basis of programming.

介紹了平面彎曲梁的剪力與彎矩的數學模型,這是編程計算的基礎。

According to the detailed examples,the shear force of a short-limb shear wall is approximately distributed with its bending stiffness,although the shear force acting on the outer short-limb shear w.

通過對短肢剪力墻結構在地震作用下的協同工作分析,建立了樓層單元力學模型,并在假設連梁兩端為鉸支的條件下得到了短肢剪力墻內力和位移的計算公式。

The shearing resistance was tested at different rotary speeds.

采用復合攪拌摩擦點焊的方法對2mm LF21鋁合金薄板進行焊接,測試了不同旋轉速度下的焊接接頭的抗剪力,并觀察和分析了點焊接頭的成形及微觀組織。